VIEW THE MSDS

199

ALCO AIR-GUARD

DESCRIPTION
ALCO Air-Guard is a self-adhering air barrier and flashing membrane. It is a roll product, nominally 40 mils thick, consisting of a self adhering rubberized asphalt membrane laminated with a polyethylene film and reinforced with a fiberglass mat. A film release liner prevents it from sticking to itself in the roll and allows for easy installation. Air-Guard is available in the following widths:  12", 18", 24", 36". 

USE
:  Pre-Cast concrete  :  Masonry Block Walls  :  Plywood  :  Primed Galvanized Metal  :  Primed Steel   
  
ADVANTAGES
»  Extremely flexible Modified Membrane  »  Forms an immediate air/vapor barrier  »  Low Permeability  »  Simple to Install  »  Above grade protection from air, vapor and water on a range of construction materials  »  Excellent Adhesion  »  Potential reduction in heating and air conditioning costs    

PREPARATION

Before application, surface must be smooth, clean, dry and free form oil, form release agents, loose scaling, rust, dirt, dust and debris. Surface must also be frost-free. Strike masonry joints flush. Concrete surfaces must be smooth and without large voids, spalled areas or sharp protrusions. Where a curing compound is used, they must be clear resin based (without oil, wax or pigments). All surfaces should be primed with ALCO Roof and Concrete Primer. 

APPLICATION
ALCO AIR-GUARD air barrier and flashing membrane can be applied at a minimum temperature of 40° F. (4° C.). Apply to a primed surface by removing the release film and rolling the membrane firmly into place. Remove the release film as material is being used. Leave no fish mouths or wrinkles. Use a utility knife for all necessary cutting. Overlaps should be 2". Use a termination bar to tie into the wall system. Use ALCO 24/7 Flashing Cement for sealing top edges of termination bar. 
Note: A low application temperature (20° - 60° F) material is also available. Please call our office for details.
                            
SPECIFICATION
ASTM D-1970  

    FOR OUTDOOR USE ONLY

PACKAGING
75' Roll Length
Roll Width:  12"       3/Carton           25 Ctn/Pallet
                  18"       2/Carton           25 Ctn/Pallet 
                  24"       1/Carton           25 Ctn/Pallet
                  36"       1/Carton           25 Ctn/Pallet

LIMITATIONS
* Do not use in areas where membrane will be subjected to continuous sunlight or temperatures in excess of 170° F.  *  Do not apply primer or AIR-GUARD to a damp, frosty or contaminated surface  *  Not compatible with Coal Tar 

FOR FURTHER SAFETY INFORMATION SEE MSDS REGARDING THIS PRODUCT
                  

WARRANTY
We warrant our materials to be of good quality and will replace materials found defective, providing, however, that the buyer shall examine the materials when received and promptly notify us of any defects before the materials are used or incorporated into a structure for which they are intended. Unless otherwise agreed to in writing, this warranty shall extend only to comply with specifications of materials manufactured by and published by ALCO-NVC Inc., and made available to the buyer at request. We cannot warrant nor in any way guarantee particular methods, use or applications, nor can we warrant that the materials will be suitable for any intended use. This warranty is in lieu of all others expressed or implied and may not be extended by representatives, written sales or information or drawings. Nor do our distributors or salesmen or any other representatives of distributors or of this  company have any authority to extend any guarantee beyond that outlined above or to waive the limitations of the seller's liability.


Give us a call at (800) 323-0029, we'll tell you even more!

ALCO NVC
ALCO-NVC Inc.   580 St. Jean   Detroit, MI 48214-0001
Toll Free: (800) 323-0029   Fax: (313) 331-4726



HOME | ABOUT US | PRODUCTS | SYSTEMS | MSDS | CONTACT | REQUEST


© ALCO NVC, INC. ALL RIGHTS RESERVED. WEB SITE BY:
DIVERSIFIED COMPUTER SERVICES, INC.