ALCO-NVC, Inc. (800) 323-0029 -- Detroit, Michigan

218

WHITE ACRYLIC ROOF COATING

DESCRIPTION
ALCO MERIC White Acrylic Roof Coating is formulated from top quality acrylic latex emulsion, titanium dioxide pigment and other special ingredients, producing an excellent roof coating with long term adhesion and high resistance to chalking.

USE
: Excellent for coating metal and concrete roof surfaces

ADVANTAGES
» Brilliant white color contributes significantly to reducing interior temperatures by reflecting the sun's rays » Special formulation techniques result in a non-separating freeze-thaw stable product » High solids content results in minimum shrinkage and maximum retention of coating to surface after drying » Can be applied on damp surface

PREPARATION
The surface must be free and clear of all loose and peeling coating, dirt, oil, grease and other foreign materials. Remove all rust with wire brush. It is highly recommended that all surfaces be power washed using a mild detergent. After cleaning, the roof should be hosed down to thoroughly remove contaminants. All joints, seams and cracks should be repaired before application of coating . On metal roofs, priming rust spots is recommended.

APPLICATION
Pour coating onto a small area and spread with a roller or soft brush. This material can also be applied with an airless sprayer. Apply uniformly with a heavier coat around vents and seams. It may be necessary to cool down a hot roof by spraying with water to prevent excessive fast drying of coating. The roof may be coated when damp but not when there is standing water.
Apply only when coating will not be subjected to heavy dew or rain before the coating has dried (approximately 5 hours).
Hands and tools may be easily cleaned with soap and water.
CAUTION: If the coating is rained on or becomes wet before it is thoroughly dry, there is a possibility that the material may dilute and run off the roof onto other surfaces. Should this happen, clean the stained surfaces as soon as possible with soap and water.

COVERAGE
40 - 50 SF/Gallon

VOC
Not to Exceed: 130 g/L     1.08 Lbs/Gal
               FOR OUTDOOR USE ONLY
            DO NOT THIN THIS PRODUCT
        SECURE COVER WHEN NOT IN USE

PACKAGING
5 Gallon Pail        36/Pallet
55 Gallon Drum     4/Pallet

LIMITATIONS
* Do not use on wood * For professional use only * May not be compatible with some one-ply systems. Check with manufacturer of roof system before application * PROTECT FROM FREEZING

PROPERTIES
Weight per Gallon: 12.4 Lbs
Viscosity @ 80° F. (ASTM D-562): 110 - 140 KU
Percent Non-Volatile (Fed Test Method 141): 60% +
Percent of Latex Solids: 20% +
Percent of Total Solids, by Volume: 50%
Dry Film Thickness of 1 Gal/100 SF: 1/64"
Service Temperature: -30° to 180° F.
Resistance to Aliphatic Solvents: Good
Resistance to Ultra Violet Light: Excellent
Dry Time - To Touch: 3 Hours
Weathering: Slight Chalking
Resistance to Water:
Under Good Drainage Conditions: Excellent
Under Continuous Submersion: Not Recommended
Clean Up: Warm, Soapy Water

FOR FURTHER SAFETY INFORMATION SEE MSDS REGARDING THIS PRODUCT

PRECAUTIONS
Hazard Rating: Health - 1 Fire - 0 Reactivity - 1
(0 = Least; 4 = Extreme)
Respiratory: Use with adequate ventilation. Inhalation of high vapor concentration may cause headaches and/or dizziness. NIOSH/MSHA approved respirators required if TLV is exceeded.
Personal Protection: Avoid prolonged or repeated contact with skin, which may cause irritation. Wear chemical resistant gloves. Goggles are recommended; a must if spraying. Wear protective clothing if needed. Launder clothing before reuse.
Fire Protection: Keep away from heat and open flame and any sources of ignition. Material in liquid state is non-flammable. Dry polymer can burn.
First Aid: Eye Contact - Rinse immediately with water for 15 minutes and seek medical advice. Skin Contact - Wash with soap and water. Inhalation - Remove individual to fresh air. If breathing is difficult, administer oxygen. If breathing has stopped, give artificial respiration; get emergency medical attention and keep victim warm. Ingestion - Contact a physician immediately.
Waste Disposal: Seal container when not in use. Empty containers must be disposed in an approved landfill in accordance with local, state and Federal regulations.

KEEP OUT OF REACH OF CHILDREN!

WARRANTY
We warrant our materials to be of good quality and will replace materials found defective, providing, however, that the buyer shall examine the materials when received and promptly notify us of any defects before the materials are used or incorporated into a structure for which they are intended. Unless otherwise agreed to in writing, this warranty shall extend only to comply with specifications of materials manufactured by and published by ALCO-NVC Inc., and made available to the buyer at request. We cannot warrant nor in any way guarantee particular methods, use or applications, nor can we warrant that the materials will be suitable for any intended use. This warranty is in lieu of all others expressed or implied and may not be extended by representatives, written sales or information or drawings. Nor do our distributors or salesmen or any other representatives of distributors or of this company have any authority to extend any guarantee beyond that outlined above or to waive the limitations of the seller's liability.

Give us a call at (800) 323-0029, we'll tell you even more!

ALCO-NVC Inc. 580 St. Jean Detroit, MI 48214-0001
Toll Free: (800) 323-0029 Fax: (313) 331-4726