|
DESCRIPTION ALCO SEAL Asphalt
Emulsion Driveway Sealer is specifically formulated to seal hairline
cracks and give new life and protection to asphalt driveway surfaces. It
protects bituminous surfaces from gasoline, oil drippings and salt, and is
fortified with acrylic polymers enabling a tighter bond to the
surface.
USE : Coat asphalt driveway surfaces :
Protects asphalt surfaces from gasoline, oil drippings and salt
ADVANTAGES » Inexpensive asphalt driveway
protection » Ready to use from the container
PREPARATION Remove deposits of dirt, grease and oil by
scrubbing with a detergent. Flush thoroughly with water, leaving no
puddles. On cracks up to 1/4" wide, fill with a quality crack filler
such as ALCO GUARD Crack Sealant.
APPLICATION Apply on a warm, sunny day at temperatures above
50° F. with no forecast of rain or freezing temperatures within 24 hours
of job completion.
Thoroughly stir material and apply with a soft bristled broom or a rubber
edged squeegee. Work the driveway sealer into the surface, spreading a
thin, even coat. Do not apply too thickly. If a thicker result is
preferred, a two coat application is recommended. Allow 24 hours for
material to cure between coats. Normal traffic can be resumed after 24
hours of job completion.
NOTE: Allow new (freshly placed) pavement to weather approximately 90 days
before sealing.
Caution: PROTECT FROM FREEZING
APPROXIMATE COVERAGE 75 - 100 SF/Gallon
VOC
Not to Exceed: 96 g/L 0.08 Lbs/Gal
DO NOT THIN THIS PRODUCT
FOR OUTDOOR USE ONLY
SECURE COVER WHEN
NOT IN USE
PACKAGING 5 Gallon Pail
36/Pallet 55 Gallon Drum 4/Pallet
LIMITATIONS *
Do not apply to concrete surfaces * Do not apply to surfaces
coated with a Coal Tar emulsion within the past 12 months * Do
not apply if temperature is expected to drop below 50° F. during the next
24 hours * Will not span large cracks or voids *
Not intended to repair broken pavement * For professional use
only * PROTECT FROM FREEZING
PROPERTIES Weight per Gallon (Approximate):
9.4 Lbs
Flash Point: N/A
Dry Time: 24 Hours
Viscosity @ 80° F.: 30,000 cps
Service Temperature: -20° to 150° F.
Resistance to Oils and Solvents: Good
Resistance to Sunlight: Good
Resistance to Chemicals: Good
Resistance to Water:
Under good drainage conditions: Good
Under poor drainage conditions: Fair
FOR FURTHER SAFETY INFORMATION
SEE MSDS REGARDING THIS PRODUCT
PRECAUTIONS Caution Contains Petroleum
Hydrocarbons Hazard Rating: Health
- 1 Fire - 0 Reactivity -
0
(0 = Least; 4 = Extreme) Personal Protection: Avoid prolonged or repeated
contact with skin, which may cause irritation. Wear chemical resistant gloves. Do not get in eyes;
wear protective goggles or face shield. Wear protective clothing if needed.
Do not take internally. Fire Protection: Non-flammable First Aid: Eye Contact - Rinse
immediately with water for 15 minutes and seek medical
advice. Skin Contact - Wash with waterless hand cleaner and/or
soap and water. Ingestion - Do
not induce vomiting. Get medical attention immediately. Waste
Disposal: Seal container when not in use. Empty containers must be
disposed in an approved landfill in accordance with local, state and
Federal regulations.
KEEP OUT OF REACH OF CHILDREN!
WARRANTY
We warrant our materials to be of good quality and will
replace materials found defective, providing, however, that the buyer
shall examine the materials when received and promptly notify us of any
defects before the materials are used or incorporated into a structure for
which they are intended. Unless otherwise agreed to in writing, this
warranty shall extend only to comply with specifications of materials
manufactured by and published by ALCO-NVC Inc., and made available to the
buyer at request. We cannot warrant nor in any way guarantee particular
methods, use or applications, nor can we warrant that the materials will
be suitable for any intended use. This warranty is in lieu of all others
expressed or implied and may not be extended by representatives, written
sales or information or drawings. Nor do our distributors or salesmen or
any other representatives of distributors or of this company have
any authority to extend any guarantee beyond that outlined above or to
waive the limitations of the seller's liability.
Give us a call at (800)
323-0029, we'll tell you even more!

ALCO-NVC Inc.
580
St. Jean Detroit, MI 48214-0001 Toll Free: (800)
323-0029 Fax: (313)
331-4726
HOME | ABOUT US |
PRODUCTS | SYSTEMS |
MSDS | CONTACT | REQUEST
© ALCO NVC, INC. ALL RIGHTS RESERVED. WEB SITE BY: DIVERSIFIED
COMPUTER SERVICES, INC.
|