|
DESCRIPTION
ALCO SHIELD HT Ice and Water Protector is designed
to be used under standing seam metal roofing, metal shingles and metal roof
panels.
USE
ALCO SHIELD HT is recommended for use under metal roof panels or granular
surface membranes.
ADVANTAGES
» High temperature resistance of 240° F. plus » Easy
installation film surface with split back self-adhering technology
» Seals around nail, metal roofing fasteners and metal screws
» Fiberglass reinforced » Waterproofing layer »
Designed for metal roofs
PREPARATION
Roof must be swept clean of all dirt and debris. The roof deck must be smooth
and dry prior to application. Always check the weather to ensure no rain is
in the forecast and the temperature is above 40° F.
WHEN RE-ROOFING: Shingles, metal roof, felts, all nails, fasteners and debris
must be removed and deck must be swept and cleaned. Replace deck as
needed.
APPLICATION
In full surface application under metal roof decking, begin at the eaves,
applying product from the low point to the high point of the roof. The rolls
should be applied running horizontally. The selvage edge must be nailed every
18" covering nails by overlapping with the next sheet. Adequate
ventilation should always be considered. Apply according to metal roof manufacturer's
specifications.
FOR EXTERIOR USE ONLY
COVERAGE
Approximately 200 SF/Roll
SPECIFICATION
ASTM D-1970
PACKAGING
2.0 SF
Roll
25/Pallet
(Approximate Roll Weight: 55 Lbs [30.4 kg])
LIMITATIONS
* Do not use on damp surfaces *
Must be covered within 30 days * Do not use under domed
roofs * For bet results do not apply at temperatures below 40°
F. * Do not store at temperatures above
100° F.
PROPERTIES
Approximate Roll Weight:
2.0 Square
55 Lbs
Membrane Width:
Membrane: 36"
Release: 37.5"
Membrane Length:
2.0 Square Roll: 66.6 Feet
Membrane Thickness: Approximately 55 mils
Application Method: Self Adhering
Surface Composition: Film Surface
Membrane Reinforcement: Fiberglass Mat
Backing Material: Silicone Coated Release Film
Service Temperature: Not to Exceed 240° F.
FOR
FURTHER SAFETY INFORMATION SEE MSDS REGARDING THIS PRODUCT
WARRANTY
We warrant our
materials to be of good quality and will replace materials found defective,
providing, however, that the buyer shall examine the materials when received
and promptly notify us of any defects before the materials are used or
incorporated into a structure for which they are intended. Unless otherwise
agreed to in writing, this warranty shall extend only to comply with
specifications of materials manufactured by and published by ALCO-NVC Inc.,
and made available to the buyer at request. We cannot warrant nor in any way
guarantee particular methods, use or applications, nor can we warrant that
the materials will be suitable for any intended use. This warranty is in lieu
of all others expressed or implied and may not be extended by
representatives, written sales or information or drawings. Nor do our
distributors or salesmen or any other representatives of distributors or of
this company have any authority to extend any
guarantee beyond that outlined above or to waive the limitations of the
seller's liability.
Give us a call at (800)
323-0029, we'll tell you even more!
ALCO-NVC
Inc. 580 St. Jean Detroit, MI
48214-0001
Toll Free: (800) 323-0029 Fax: (313) 331-4726
HOME | ABOUT
US | PRODUCTS | SYSTEMS
| MSDS | CONTACT | REQUEST
© ALCO NVC, INC. ALL RIGHTS RESERVED. WEB SITE BY: DIVERSIFIED COMPUTER
SERVICES, INC.
|