|
DESCRIPTION
ALCO SEAL Acrylic
Concrete Cure and Seal 430-1315 is a ready to use, crystal clear solution,
formulated with special acrylic co-polymers, which are carried in solution
by quick evaporating solvents. Its non-yellowing formula economically
cures and seals freshly poured concrete.
USE
Ideal for commercial and industrial concrete surfaces as
well as sidewalks, patios, parking areas, driveways and decks.
ADVANTAGES
» Provides a tough, long lasting
finish » Resists oil, grease, de-icing salts and most
chemicals » Both cures and seals »
Non-Yellowing » Moisture impermeable
PREPARATION
Before application, be sure that all surface
water has disappeared from the surface and workmen cannot mar concrete
surface.
APPLICATION
Apply when surface water has completely
disappeared from the surface and workmen cannot mar the surface.
Temperature must be above 40° F. before application. Use a standard hand
held garden type sprayer with neoprene hose and gaskets, or a short napped
roller. Avoid puddling during application and restrict traffic for at
least 4 hours (12 hours preferable) after application.
If additional sealing is desired, ALCO SEAL Acrylic Concrete Sealer
440-1315 may be applied after 7 days.
COVERAGE
Curing 200 - 350 SF/Gallon
Sealing 300 - 500 SF/Gallon
SPECIFICATION
ASTM C-309, Type I, Class B
ASTM C-1315, Type I, Class A
AASHTO M 148, Type I, Class B
VOC
This product meets the maximum VOC content limit (700 g/L) for
concrete curing and sealing compounds as required by the US EPA
Architectural Coatings Rule.
FOR OUTDOOR USE ONLY
DO NOT THIN THIS PRODUCT
SECURE COVER WHEN NOT IN USE
PACKAGING
1 Gal
Can
6/Carton
5 Gallon Pail
36/Pallet
55 Gallon Drum 4/Pallet
LIMITATIONS
*
Do not use where food items are present * Do not apply
if the concrete surface temperature is below 40° F. * May not
be used on materials that are not uniform in porosity or have a non-porous
surface such as brick, stone, masonry, slate, etc. * This product is
not a waterproofing sealer for masonry surfaces
FOR FURTHER SAFETY
INFORMATION SEE MSDS REGARDING THIS PRODUCT
PRECAUTIONS
Caution Combustible
Contains Petroleum
Distillate
Hazard Rating: Health
- 1 Fire - 2 Reactivity -
0
(0 = Least; 4 = Extreme)
Respiratory: Use with adequate ventilation. Inhalation of high vapor
concentration may cause headaches and/or dizziness. NIOSH/MSHA approved
respirators
required if TLV is exceeded.
Personal Protection: Avoid prolonged or repeated
contact with skin, which may cause irritation. Chemical resistant gloves
such as neoprene are recommended.
Do not get in eyes; splash proof goggles are recommended. Wear protective clothing if needed. Do not take
internally.
Fire Protection: Keep away from heat, open flame and
any source of ignition.
First Aid: Eye Contact - Rinse
immediately with water for 15 minutes and seek medical advice. Skin Contact - Wash thoroughly with soap and water. Inhalation
- Remove individual to fresh air. If breathing is difficult, administer
oxygen. If breathing has stopped, give artificial respiration; get medical
attention immediately and keep victim warm. Ingestion - Do
not induce vomiting. Get medical attention immediately.
Waste
Disposal: Seal container when not in use. Empty containers must be
disposed in an approved landfill in accordance with local, state and
Federal regulations.
KEEP OUT OF REACH OF CHILDREN!
WARRANTY
We warrant our materials to be of good quality and will
replace materials found defective, providing, however, that the buyer
shall examine the materials when received and promptly notify us of any
defects before the materials are used or incorporated into a structure for
which they are intended. Unless otherwise agreed to in writing, this
warranty shall extend only to comply with specifications of materials
manufactured by and published by ALCO-NVC Inc., and made available to the
buyer at request. We cannot warrant nor in any way guarantee particular
methods, use or applications, nor can we warrant that the materials will
be suitable for any intended use. This warranty is in lieu of all others
expressed or implied and may not be extended by representatives, written
sales or information or drawings. Nor do our distributors or salesmen or
any other representatives of distributors or of this company have
any authority to extend any guarantee beyond that outlined above or to
waive the limitations of the seller's liability.
Give us a call at (800)
323-0029, we'll tell you even more!
ALCO-NVC Inc.
580
St. Jean Detroit, MI 48214-0001
Toll Free: (800)
323-0029 Fax: (313)
331-4726
HOME | ABOUT US |
PRODUCTS | SYSTEMS |
MSDS | CONTACT | REQUEST
© ALCO NVC, INC. ALL RIGHTS RESERVED. WEB SITE BY: DIVERSIFIED
COMPUTER SERVICES, INC.
|