MATERIAL SAFETY DATA SHEET

ALCO-NVC, Inc Dated: February 25, 1993

PO BOX 14001 Revised: December 1, 1998

580 ST JEAN 313-823-7500 Reviewed: February 11, 2009

DETROIT MI 48214 FAX: 313-331-4726

PRODUCT: #218C White Patching Cement

SECTION 1 PRODUCT IDENTIFICATION

Trade Name: White Roof Cement

Description: A dispersion of polymers, water and inert fillers

Hazardous Rating: 1 – Health 0 – Fire 0 – Reactivity

(0 = Least; 4 = Extreme)

SECTION 2 HAZARDOUS INGREDIENTS

None known

SECTION 3 PHYSICAL/CHEMICAL DATA

Boiling Point: 200° - 215° F.

Vapor Density (Air = 1): > 1

Specific Gravity: 1.0 +

Evaporation Rate (BUAC = 1): < 1

Vapor Pressure (mm Hg): 20° X. 18mm

Soluble in Water: Miscible

Appearance: Thick, white liquid

SECTION 4 FIRE & EXPLOSION DATA

Flash Point: Not Applicable – Water Based Material

Flammable Limits in Air: Lower – Not Applicable

Upper – Not Applicable

Fire Fighting Procedures: Will not burn as supplied

SECTION 5 REACTIVITY DATA

This material is stable.

Materials to Avoid: Not Applicable

Hazardous Polymerization: Will no occur

Decomposition Products: Oxides of Carbon and Nitrogen

SECTION 6 HEALTH HAZARD DATA

Primary Routes of Entry: Inhalation, Skin, Ingestion, Eyes

Effects of Overexposure (Chronic): None Known

Effects of Over Exposure (Acute):

Inhalation – Use with adequate ventilation. Inhalation of high vapor concentration may cause

headaches and/or dizziness. This material is for exterior use only.

Skin – Prolonged contact may cause irritation and/or dermatitis.

Ingestion – Can cause gastrointestinal irritation.

Eyes – May cause irritation, blurred vision.

SECTION 7 FIRST AID PROCEDURE

Skin: Wash with mild soap and water. If redness, etc., persists, consult a physician.

Eyes: Flush with large amounts of water. Consult a physician.

Inhalation: Vapor may aggravate sensitive tissues, nasal and respiratory passages. Remove person from
area. If breathing is difficult, give artificial respiration. Seek immediate medical aid.

Ingestion: Do not induce vomiting. Consult a physician immediately.

SECTION 8 PREVENTATIVE MEASURES/SAFE HANDLING & USE

Leak and Spill Procedure: Dike material with earth, sawdust or sand. The material will cure to a solid, dry
film. Keep out of waterways and sewers.

Waste Disposal: Dispose in an approved landfill following Federal, state and local regulations.

Precautions in Handling & Storage: DO NOT FREEZE. Do not heat this material. This material is for
exterior use only. Avoid prolonged contact with skin. Practice good personal hygiene. Read label of
product in its entirety before use. DO NOT HEAT OR THIN THIS MATERIAL!

KEEP OUT OF REACH OF CHILDREN!

SECTION 9 CONTROL PROTECTION DATA

Ventilation: Normally not needed.

Gloves: Oil resistant recommended.

Eye Protection: Chemical splash proof goggles recommended. If material is sprayed, goggles are a must.

Personal Protection Equipment: Requirements must be supplied by the user, depending on use
conditions.

SECTION 10 REGULATORY INFORMATION

Reportable Quantities: Not Applicable

RCRA Hazard Waste No.: Not applicable

Proper Shipping Name: Paint

Hazard Class: Not regulated under CFR 49, Section 173, 118A

Identification Number: NMFC Item #170150

Labels Required: Identity, Hazard Warning, Name and Address of responsible party.

VOC: 130 Grams/Liter Maximum

SECTION 11 SHIPPING INFORMATION

DOT Shipping Name: Not Regulated

ID #: None

Labels Required: None

Packaging Requirements (49 CFR): None

SECTION 12 USER RESPONSIBILITY

This product material safety data sheet provides health and safety information. The product is to be used in applications consistent with our product literature. Individuals handling this product must be informed of the recommended safety precautions and must have access to this information. For any other uses, exposures must be evaluated so that appropriate handling practices and training programs can be established to ensure safe work place operations. Please consult your local sales representative for any further information.

SECTION 13 CLEAN UP AND DISPOSAL

Practice good personal hygiene. Launder contaminated clothing before reuse. Use control protection such as chemical splash proof goggles, oil resistant gloves, barrier cream. To prevent repeated skin contact, wear impervious clothing. Clean tools and equipment with kerosene, adhering to manufacturer’s precautions. DO NOT USE GASOLINE OR NAPHTHA. Follow proper container management in disposing of containers. CERCLA amendment on disposal of containers should be followed.

SECTION 14 DISCLAIMER

The information set forth herein is believed to be accurate but is not warranted to be, whether originating with ALCO-NVC, Inc or not. Recipients are advised to confirm in advance of need that the information is current, applicable and suitable to their circumstances.

This Material Safety Data Sheet supersedes all other previously dated sheets for this product.